Filter
Top Products
Power Connection
a AC power connector — Plug a standard IEC power cord into this connector to connect
the GSS to a 100 VAC to 240 VAC, 50 or 60 Hz power source.
Signal Connections
b RGB Pass-through connectors — Connect a high resolution or computer input (VGA,
SVGA, XGA, SXGA, or UXGA) to these female BNC connectors.
c Output connectors — Connect an RGB video display or other device to these female
BNC connectors (see gure 3 to connect the RGB video format for each conguration).
RGBHV
R
RGBS
G B H/HV V
R
G B H/HV V
Figure 3. Video Output Connection Format
NOTE: The still image output format (RGBHV or RGBS) must be congured using
the front panel controls or a Simple Instruction Set (SIS™) command. The
output format applies only to the output of still images stored in the GSS;
the RGB Pass-through video is output exactly as it is input.
Remote Connections
Ethernet connection
d LAN port — Connect the GSS to a PC or to an Ethernet LAN, via this RJ-45 connector.
You can use the HTML pages embedded in the GSS to upload still images from the PC
to the GSS and to control the GSS. You can also use a PC to control the GSS with SIS
commands.
Link LED indicator — The green (link) LED indicates that the GSS 100 is
properly connected to an Ethernet LAN. This LED should light steadily.
Act LED indicator — The yellow (activity) LED indicates transmission
of data packets on the RJ-45 connector. This LED should icker as the
GSS 100 communicates.
Cabling
It is vital that your Ethernet cables be the correct cable type and that they be correctly
terminated with the proper connector pinout. Ethernet links use Category (CAT) 3, 5e, or 6,
unshielded twisted pair (UTP) or shielded twisted pair (STP) cables, terminated with RJ-45
connectors. Ethernet cables are limited to a length of 328 feet (100 m).
NOTES: • Do not use standard telephone cables. Telephone cables do not support
Ethernet or Fast Ethernet.
• Do not stretch or bend cables. Transmission errors can occur.
The cable used depends on your network speed. The GSS 100 supports both
10 Mbps (10Base-T — Ethernet) and 100 Mbps (100Base-T — Fast Ethernet), half-duplex
and full-duplex Ethernet connections.
10Base-T Ethernet requires CAT 3 UTP or STP cable at minimum.
100Base-T Fast Ethernet requires CAT 5e UTP or STP cable at minimum.
Link
LED
Activity
LED
GSS 100 Graphic Still Store • Installation 4