Filter
Top Products
5
ENGLISH
1. GENERAL INFORMATION
(2) Rear panel
ANALOG OUTPUT
L
R
FIXED VARIABLE
RS232C PARALLEL
LAN
SPDIF AES/EBU
L
R
LEVELLEVEL
RL
DIGITAL OUTPUT REMOTE
2 HOT(
+
)
3 COLD(
-
)
1 GND
SERIAL NO.
xnm.zvb ,c
z
ANALOG (Balanced) OUTPUT
• These are active balanced outputs using XLR type
connections. The CD's or network's audio playback
signals are output from these connectors.
• Pin layout : 1. GND / 2. Hot / 3. Cold
• Applicable connector :
Cannon XLR-3-31 or equivalent.
NOTE :
• Do not short-circuit the hot or cold pin with the
common pin.
x
LEVEL Control
• Use these controls to adjust the level of the audio
signals from the BALANCED OUT connectors.
c
ANALOG (Unbalanced) OUTPUT
• These are unbalanced outputs using RCA type jacks.
• VARIABLE
Use the remote control unit or web GUI to adjust the
output level.
v
DIGITAL (SPDIF) OUTPUT
• This is a coaxial output using an RCA type jack.
• Signal format : SPDIF(IEC-958 Type II) or AES/EBU
(select in menu)
• Sampling frequency : 32 /44.1 /48 /Auto (select in
menu)
b
DIGITAL (AES/EBU) OUTPUT
• This is a balanced output using an XLR type jack.
1.Common / 2.Hot / 3.Cold.
• Signal format : SPDIF(IEC-958 Type II) or AES/EBU
(select in menu)
• Sampling frequency : 32 /44.1 /48 /Auto (select in
menu)
• Applicable connector: cannon XLR-3-31 or equivalent
n
RS232C connector
Connector for serial control from an external device.
m
PARALLEL connector
Connector for parallel control from an external device.
,
LAN connector
10BASE-T and 100BASE-TX RJ-45 LAN terminal for
network connection.
.
AC inlet
Connect the included power cord here.