Denon AVR-3803 Stereo System User Manual


 
53
[2]Outputting a program source to an amplifier, etc., in a different room (ZONE2 mode)
1
Press the ZONE2 button.
3
With ZONE2 SOURCE displayed, turn
the FUNCTION knob and select the
source you wish to output.
The indicator of the selected source
light.
FUNCTION
4
Start playing the source to be output.
For operating instructions, refer to the manuals of the
respective components.
5
To cancel, turn the function knob and
select SOURCE.
FUNCTION
33,5
2
1
VCR -1 -2 / TAPE -1 -2
PHONO CD TUNER DVD / VDP TV / DBS
2
MULTI
ZONE2 SOURCE
Display
NOTES:
The signals of the source selected in the ZONE2 mode are also
output from the VCR-1, VCR-2 and CDR/TAPE recording output
jacks.
Digital signals are not output from the ZONE2 audio output
jacks.
(Main unit)
(Main unit)
(Main unit)
2
Press the ZONE2/REC button.
The display switches as follows each
time the button is pressed.
(Main unit)
Light
3
2
1
4
5
2
Press the ZONE2 ON button.
To cancel the ZONE2 mode.
Press the ZONE2 OFF button.
(Remote control unit)
3
Press the input source button
The ZONE2 source switches directly.
4
The output level of the ZONE 2 OUT
terminals can be controlled using the
VOLUME + and - buttons on the remote
control unit.
The output level of ZONE 2 OUT can be
controlled only if ZONE2 vol. level is set
Variable at Zone2 Control in System
Setup Menu. (See page 28)
(Remote control unit)
DEFAULT SETTING (ZONE2 VOLUME LEVEL) :
- - - dB (MINIMUM)
5
When the ZONE2 SOURCE function is
set to TUNER, the preset channel can
be selected using the CHANNEL + and
- buttons on the remote control unit.
(Remote control unit)
The main zone output can be
turned on and off with the
MAIN ON/OFF button.
[3]Remote control unit operations during multi-source playback (selecting the input source)
1
Select ZONE2 using the AMP button.
(Remote control unit)
This operation is possible when ZONE2 mode is selected.
This operation is not possible in the REC OUT mode.