Filter
Top Products
44
(3)Resetting the system call buttons
DVD
2, 3, 4
11
2, 3, 5
1
2
Press the power ON/SOURCE button and the OFF button at
the same time.
•“PRE” appears on the remote control unit’s display.
Use the • and ª cursor buttons to display “RST” on the
remote control unit, then press the ENTER button.
•“PRE” appears on the remote control unit’s display.
3
Use the • and ª cursor buttons to display “CALL” on the
remote control unit, then press the ENTER button.
•“SEL” appears on the remote control unit’s display.
5
To reset CALL 1 or CALL 2, select “CALL 1” or CALL 2”, then
press the ENTER button.
• The LCD’s back light flashes during the resetting operation,
and when the operation is completed, “OK” is displayed
and the set returns to the normal operating mode.
4
Press the • and ª cursor buttons to select the system call
setting to be reset.
The remote control unit’s display switches as shown
below each time the • and ª cursor buttons are pressed.
SYS CALL 1
SYS CALL 2