Denon AVR-3803 Stereo System User Manual


 
41
(3)Using the system call function
NOTES:
The remote control signals of the buttons pressed while registering the system call signals are emitted, so be careful not to operate the
components accidentally (cover the remote sensors, for example).
If you exceed the number of signals that can be registered, FULL appears on the remote control units display and only the number of
signals that can be registered are registered (up to 10 operations).
1
Press the button at which the system call signals have been stored.
The stored signals are transmitted successively.
Punch Through
(1)Punch through button
Buttons used in the CD, CDR, TAPE, DVD, VDP, VCR1 and VCR2
modes can be assigned to the buttons shown on the diagram at
the right which are not normally used in the AMP, TV, DBS and
CABLE modes.
For example, when the CD mode is set to the punch through mode
in the AMP mode, the CD modes PLAY, STOP, MANUAL
SEARCH, AUTO SEARCH, PAUSE and DISC SKIP buttons signals
are sent in the AMP mode.
(2)Making the punch through setting
1
2
Press the power ON/SOURCE button and the OFF button at
the same time.
PRE appears on the remote control units display.
Use the and ª cursor buttons to display PUNCH on the
remote control unit, then press the ENTER button.
SEL appears on the remote control units display.
DVD
2, 3, 4
11
(1)
2, 3, 4
3
Use the and ª cursor buttons to display the mode for which
you want to make the punch through setting, then press the
ENTER button.
SEL appears on the remote control units display.
TV
AMP
CABLE
DBS
It is also possible to select the mode directly using the
mode buttons.
The display switches as shown below each time the and
ª cursor buttons are pressed.
4
Use the and ª cursor buttons to display the mode you want
to punch through, then press the ENTER button.
OK is displayed and the punch through is set.
CD CDR
MD
TAPE
DVD
VDP
VCR2 VCR1
It is also possible to select the mode directly using the
mode buttons.
The display switches as shown below each time the and
ª cursor buttons are pressed.