Denon AVR-3803 Stereo System User Manual


 
19
Parameters
Large...................Select this when using speakers that have sufficient performance for reproducing bass sound below the frequency set for the
Crossover Frequency mode.
Small...................Select this when using speakers that do not have sufficient performance for reproducing bass sound below the frequency set
for the Crossover Frequency mode. When this is set, bass sound with a frequency below the frequency set for the Crossover
Frequency mode is sent to the subwoofer.
When this setting is selected, low frequencies of below the frequency set for the Crossover Frequency mode are assigned
to the subwoofer.
None……............Select this when no speakers are installed.
Yes/No.............Select Yes when a subwoofer is installed, No when a subwoofer is not installed.
2spkrs/1spkr.......Set the number of speakers to be used for the surround back channel.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when Small is set for the front, center
and surround speakers.
For the majority of speaker system configurations, using the SMALL setting for all five main speakers and Subwooofer On with a connected
subwoofer will yield the best results.
2
Enter the setting.
When Front is set to Large and Subwoofer is set to Yes, the set switches to the subwoofer mode.
Speaker type setting when using both surround speakers A and B
If Small is set for either surround speakers A or B, the output is the same as when Small is set for both A and B.
Selecting the Surround Speakers for the different surround modes
This screen is displayed when using both surround speakers A and B.
At this screen preset the surround speakers to be used in the different surround modes.
1
When either Large or Small has been set for both speakers A and B
on the System Setup Menu (when using both A and B surround
speakers), the surround speaker setting screen appears.
Select the surround speakers to be used in the different surround modes.
To select the surround mode
To select the surround speaker
A: When using surround speakers A
B: When using surround speakers B
A+B: When using both surround speakers A and B
Setting the crossover frequency and low frequency distribution when playing Dolby Digital
and DTS signals
1
Select the Crossover Frequency mode.
This screen is not displayed when not using a subwoofer.
Set the crossover frequency and subwoofer mode according to the speaker system being used.
Select the frequency.