Filter
Top Products
47
speaker setup The Speaker Setup menu (found via the following path: system setup/speakers)
allows you to tell the SSP-600 about the speakers with which it is working, so it
can provide the best and most appropriate signals to each speaker.
• speaker config allows you to customize your speaker configuration and
set up the bass management within the SSP-600. Each group of speakers
(other than the subwoofer) can be specified as
large (meaning “capable of
handling any low frequency that might exist in that channel’s signal”)
, small
(meaning “might be overloaded by loud, low frequency information that might
exist in that channel’s signal)
, or none (meaning “my system does not use these
speakers”). If you set the surround speakers
to none, the rear speakers
button will not be available.
• subwoofer configuration, available from the Speaker Config menu, is
where you determine whether you have a subwoofer in the system. If
you engage
sub enabled, the LFE (Low Frequency Effects) information
in many movie soundtracks will be routed to it, along with any bass
information from speakers you designated as “small.” If you do not have
a subwoofer, all such bass information will be routed to any speakers
you designated as “large.” If you prefer to send all such deep bass
information to all speakers that are designated as “large” as well as the
subwoofer, engage both
sub enabled and e-bass (“enhanced bass”).
• system crossover determines the frequency below which signals will
be re-routed away from any speaker designated as “small.” The default
THX setting for this crossover (which should be used if you are using
THX-certified loudspeakers) is 80 Hz. You may choose any frequency
from 40-140 Hz, in 10 Hz increments. There is also a crossover on/off
toggle in the system crossover screen. Be sure it is on (highlighted) if
you have any “small” speakers in your system.