Filter
Top Products
SC3100
Installation
SC3100 Operation and Installation Guide
© 2004 Bosch Security Systems Page 19 90026-201D
4.0 Installation Procedures
This section describes the installation procedures for the SC3100 Radio Communicator.
4.1 SC3100 Radio Communicator
Mount the SC3100 at the location determined from the considerations discussed in Section 3.0. The total weight
of the SC3100 is about one pound (0.5 kg) with the internal 12 VDC battery installed.
The SC3100 is normally installed in an upright position in the bottom and inside of the host alarm panel
enclosure (see Figure 3).
SC3100
HOST ALARM PANEL
SAFECOM
SAFECOM ANTENNA
CONNECTOR
FACTORY SUPPLIED
RF COAXIAL CABLE
HOST ALARM PANEL
BATTERY
SAFECOM SC3100
RADIO COMMUNICATOR
Figure 3: SC3100 Radio Communicator
4.2 Antenna
Each SC3100 Radio Communicator unit is shipped from Bosch Security Systems with a 20 in. (50.8 cm) antenna
coaxial cable assembly to mount the antenna directly on the host alarm panel enclosure (as shown above). The
unit is also shipped with a 2" x 2" antenna mounting L-bracket for mounting the antenna directly on the side of
the host alarm panel or for remote installation of the antenna.
If mounting the antenna directly on the host alarm panel, use the attached antenna coaxial cable assembly to
connect the SC3100 radio communicator to the antenna (on the top of the host alarm panel enclosure). See the
following figure:
HOST ALARM
PANEL
ENCLOSURE
WITH KNOCK-
OUT REMOVED
MOUNTING WASHER
MOUNTING WASHER
ANTENNA CONNECTOR
Figure 4: SC3100 Antenna