Barco R9010040 Home Theater System User Manual


 
4. Getting Started
6 STBY standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. W hen the projector is running and you want to
go to standby, press the standby key for 2 se conds until the m essage ’Saving data,
please wait’ is displayed. Do not press an y longer on the standby key otherwise
the projector will restart.
7 MUTE to interrupt the sound reproduction.
8 ? Auto image, to center the image on the active LCD surface.
9 Digit buttons direct input selection.
10 Audio controls use these buttons to obtain the desired sound level.
11 Picture controls press to adjust the projected image.
12 Phase be sure the projector is warmed up for at least 15 min before adjusting the pha se, pr ess to
adjust the phas e of the projected image.
13 FREEZ press to freeze the projected image.
14 TEXT when adjusting one of the image, e.g. controls during a meeting, the displayed bar scale
can be removed by pressing ’TEXT’ key first. To re-display the bar scale on the screen,
press ’TEXT’ key again.
15 ENTER to start up the adjustment mode or to confirm an adjustment or selection in the adjustment
mode.
16 Curso r keys to m ake menu selections w hen in the adjustment mode or to zoom/focus when the direct
access is active.
Comparison between the cursor keys and the use of the ’+’ and ’-’ keys on the local keypad
: RCU = local keypad
cursor key up = ’+’ key up
cursor key down = ’-’ key down
cursor key right = ’+’ key right
cursor key left = ’-’ key left
17 EXIT to leave the adjustment mode or to s croll upwards when in the adjustment mode.
18 RC operation indication lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
Table 4-1
24 R5976584 BA RCO CINE7 26022003