Filter
Top Products
Saving a Setup ....................................3-5
Recalling a Setup...................................3-5
Save and Recall a Display ...........................3-5
Saving a Display ...................................3-5
Recalling a Display .................................3-6
Set the Distance and Cable Type .......................3-7
Changing the Units ..............................3-7
Changing the Display Language........................3-7
Printing.....................................3-8
Printing a Screen ...................................3-8
Printer Switch Settings................................3-9
Using the Soft Carrying Case.........................3-10
Chapter 4 - Cable & Antenna Analysis
Introduction ..................................4-1
One Port Measurements ............................4-1
Line Sweep Fundamentals ...........................4-1
Information Required for a Line Sweep ....................4-2
Typical Line Sweep Test Procedures .....................4-3
System Return Loss Measurement..........................4-3
Insertion Loss Measurement .............................4-5
Distance-To-Fault (DTF) Transmission Line Test..................4-8
Antenna Subsystem Return Loss Test .......................4-10
Two Port Measurements ...........................4-12
Introduction..................................4-12
TMA Measurements .............................4-13
Antenna to Antenna Isolation.........................4-19
Introduction..................................4-19
Antenna-to-Antenna Isolation Measurement.................4-20
Chapter 5 - Site Master Software Tools
Introduction ..................................5-1
Features ....................................5-1
System Requirements .............................5-1
Installation ...................................5-2
Communication Port Setting.............................5-2
Interface Cable Installation .............................5-3
Using Software Tools .............................5-3
Downloading Traces from the Site Master ..................5-3
Plot Capture ..................................5-4
Plot Properties .................................5-4
Trace Overlay or Plot Overlay............................5-5
Saving Traces ....................................5-5
Custom Cable List ..................................5-6
Creating a Database .................................5-7
Printing Formats ...................................5-7
ii