Filter
Top Products
Selecting the Frequency Range ..........................4-3
Performing a Calibration .............................4-3
Setting the Amplitude Scale ............................4-4
Saving the Setup ..................................4-4
Recalling a Setup ..................................4-4
Saving a Display to Memory ............................4-5
Recalling a Display From Memory ........................4-5
SWR (Return Loss) and Cable Loss Measurement ............4-9
Required Equipment ................................4-9
Device-Under-Test Specification..........................4-9
Procedure ......................................4-9
Selecting the Measurement Mode .........................4-9
Selecting the Frequency Range ..........................4-9
Performing a Calibration .............................4-10
SWR or Return Loss Measurement .......................4-11
Set the Amplitude Scale and Limit Line .....................4-11
Setting the Markers ................................4-13
Cable Loss Measurement ..........................4-14
Setting the Amplitude Scale ...........................4-14
Setting the Segment Limit LInes .........................4-14
DTF Measurement .............................4-16
Required Equipment ...............................4-16
Device-Under-Test Specification .........................4-16
Procedure .....................................4-16
Selecting the Measurement Mode ........................4-16
Performing a Calibration .............................4-17
DTF Measurement (Determining the Length of the Cable) ..........4-18
Setting the Amplitude Scale ...........................4-18
Setting the Marker ................................4-18
DTF Measurement (Determining the quality of the cable.) ..........4-20
Setting the Amplitude Scale ...........................4-20
Setting the Markers ................................4-20
Insertion Gain (Amplifier) Measurement .................4-22
Required Equipment ...............................4-22
Device-Under-Test Specification .........................4-22
Procedure .....................................4-22
Selecting the Measurement ............................4-22
Selecting the Frequency Range..........................4-22
Performing a Calibration .............................4-22
Amplifier Gain Measurement ..........................4-24
Setting the Markers ................................4-24
Activating the Bias Tee ..............................4-25
Setting the Amplitude Scale ...........................4-25
Making Power Measurements .......................4-27
Entering Power Monitor Mode..........................4-27
Zeroing the Power Monitor............................4-27
Measuring High Input Power Levels.......................4-27
Displaying Power in dBm and Watts ......................4-27
Displaying Relative Power ............................4-27
ii