Filter
Top Products
Manual Actuator
Assembly
Step 1
Step 2
Step 3
32
Installation Procedures
The manual actuator assembly (P/N 207882) is used to adjust the elevation and
azimuth angles of the 3.7 meter antenna. The following steps provide the procedure
used to assemble and install the manual actuator assembly.
Loosely attach the manual actuator assembly (P/N 207882) to the elevation strut as
shown in Figure 3-22 using clamp segments, 1/4 inch screw, lockwasher and hex nut in
each of the 12 connections.
NOTE: The drain hole should be positioned downward for proper water drainage.
Attach the base angle to the actuator (P/N 202661) using 1/2 inch screws, flatwashers
and hex nuts as shown in Figure 3-22. AVOID EXCESSIVE TORQUE ON THE
MOUNTING HARDWARE.
Ensure that the locking strut-support setscrew is firmly tightened on the strut assembly
as shown in Figure 3-22.
Figure 3-22a: Manual Actuator Assembly
Figure 3-22b: Manual Actuator Assembly