Filter
Top Products
Step 3
Step 4
Step 5
Step 6
44
Installation Procedures
Figure 3-30b: Export Pack
Figure 3-30c: Unpacking
Pry the short ends of the crate off by using a pry bar and hammer as shown in Figure 3-30c.
NOTE: Notice that the parts of your order are boxed and banded to your crate. Remove
these boxes by snipping the banding with tin snips.
Take the front, long side of the crate off.
Unbolt the reflector halves from the bottom of the crate. DO NOT PRY.
Find a flat area for the reflector assembly. The area must be large enough for the reflec-
tor halves to lay adjacent to each other. Pieces of wood (such as 2” X 4” pieces) can be
positioned to provide a level surface for the reflector to rest on, which will prevent
scratching of the reflector.
Note: This area must be level or there may be problems in correctly aligning the reflector.