Filter
Top Products
22 Configuring the Digitizer Modules Chapter 1
Installing the
Digitizer in a
Mainframe
The E1563A or E1564A Digitizer can be installed in any slot (except slot 0)
in a C-size VXIbus mainframe. See Figure 1-5 for the procedure to install the
Digitizer in a mainframe.
Figure 1-5. Installing the Digitizer in a Mainframe
Set the extraction levers out.1
Slide the E1563/E1564 into any slot
(except slot 0) until the backplane
2
connectors touch.
in the extraction levers.
Seat the digitizer into
the mainframe by pushing
3
Extraction
Levers
remove the digitizer.
extraction levers may be used to guide or
flush with the front of the mainframe. The
module until the module's front panel is
seat the connectors by pushing in the
VXIbus mainframes. You must manually
seat the backplane connectors on older
NOTE: The extraction levers will not
reverse the procedure.
To remove the digitizer from the mainframe,
to the mainframe.
to secure the digitizer module
Tighten the top and bottom screws
4