Filter
Top Products
116 Digitizers Command Reference Chapter 3
INITiate
[:IMMediate]
:CONTinuous ON | 1 | OFF | 0
:CONTinuous?
Initiate a measurement now
Initiate measurements continuously
Query continuous state
INPut[<channel>]
:FILTer[:LPASs]:FREQ 1.5K | 6K | 25K | 100K (4-chan)
:FILTer[:LPASs]:FREQ?
:FILTer[:LPASs][:STATe] ON | 1 | OFF | 0
:FILTer[:LPASs][:STATe]?
[:STATe] ON | 1 | OFF | 0
[:STATe]?
Set the input filter and enable/disable input
E1564A only. E1563A has fixed 25K.
Query filter frequency
Enable/disable channel’s filter
Query filter state
Enable/disable channel’s input
Query channel input state
OUTPut
:TTLT<n>:SOURce TRIGger | SAMPle | BOTH
:TTLT<n>:SOURce?
:TTLT<n>[:STATe] ON | 1 | OFF | 0
:TTLT<n>[:STATe]?
Define trigger lines to output trigger and/or sample
Query source
Enable/disable the specified output
Query specified output
SAMPle
[:STARt | :SEQuence[1]]
:COUNt <count> | MIN | MAX
:COUNt? [MIN | MAX]
[:IMMediate]
:PRETrigger:COUNt <count> | MIN | MAX
:PRETrigger:COUNt? [MIN | MAX]
:SLOPe POS | 1 | NEG | 0
:SLOPe?
:SOURce HOLD | TIMer | TTLT0-7 | EXT
:SOURce?
:TIMer <interval> | MIN | MAX
:TIMer? [MIN | MAX]
Set the number of samples to take
Query number of samples set
Take a sample now
Set the number of pretrigger samples
Query number of pretrigger samples
Set the sample signal slope
Query the sample signal slope
Set the sample source
Query the sample source
Set sampling interval for source TIMer
Query sampling interval
[SENSe:]
DATA? <Rdgs_per_channel>[,<channel_list>]
DATA:ALL? <Rdgs_per_channel>
DATA:COUNt? [MIN | MAX]
DATA:CVTable? <channel_list>
ROSCillator:EXTernal:FREQuency <freq>
ROSCillator:EXTernal:FREQuency?
ROSCillator:SOURce INTernal | EXTernal
ROSCillator:SOURce?
SWEep:POINts <neg_value> | MIN | MAX
SWEep:POINts? [MIN | MAX]
SWEep:OFFSet:POINts <neg_value> | MIN | MAX
SWEep:OFFSet:POINts? [MIN | MAX]
VOLTage[<channel>][:DC]:RANGe <range> | MIN | MAX
VOLTage[<channel>][:DC]:RANGe? [MIN | MAX]
VOLTage[<channel>][:DC]:RESolution? [MIN | MAX]
Read data from list of channels
Read data from all channels
Query available readings per channel
Query last reading taken from channel
Declare external source’s frequency
Query external source’s frequency
Set reference oscillator source
Query reference oscillator source
Set number of sweep points
Query number of sweep points
Set number of sweep offset points
Query number of sweep offset points
Set channel’s voltage range
Query channel’s voltage range
Query channel’s resolution
Command Description