Filter
Top Products
110 Digitizers Command Reference Chapter 3
*CLS
*CLS clears the Standard Event Status Register, the OPERation Status
Register, the QUEStionable Signal Register, and the Error Queue. This
clears the corresponding summary bits (bits 3, 5 and 7) in the Status Byte
Register. *CLS does not affect the enable unmasks of any of the Status
Registers.
Comments Executable when initiated: No
Coupled command: No
Related Commands: STATus:PRESet
Reset (*RST) condition: None
*ESE and *ESE?
*ESE <unmask> enables (unmasks) one or more event bits of the Standard
Event Status Register to be reported in bit 5 (the Standard Event Status
Summary Bit) of the Status Byte Register. A 1 in a bit position enables the
corresponding event and a 0 disables it. For example, *ESE 60 enables
error events.
unmask is the sum of the decimal weights of the bits to be enabled allowing
these bits to pass through to the summary bit ESB (bit 5 in the Status Byte
Register). The query form returns the current enable unmask value.
Parameters
Comments
Executable when initiated: Yes
Coupled command: No
Related Commands: *ESR?, *SRE, *STB?
Reset (*RST) condition: unaffected
Power-On condition: no events are enabled
Name Type Range of Values Default Value
unmask numeric 0 through 255 None