April, 2007 ADDITIONAL INFORMATIONS
4-107
4.4.13 POOR FUSING ON 100g/m
2
PAPER
SYMPTOM:
Part of the image peels off the paper.
NOTE: This symptom is most noticeable under these conditions:
• When solid images are printed onto 100g/m
2
(28lb.) paper in full color mode
• When using a Ricoh PostScript3 printer driver or using Fiery controller
CAUSE:
Not enough heat is supplied to the surface of the fusing roller.
SOLUTION:
Add the "Middle Thickness Paper Mode" by the following action.
Important:
• Never change the setting for Sp1105-036 (Hot Roller Wait Temp: Norm, default
= 145 deg).
• After you finish the procedure below, turn the machine main power OFF/ON.
Solution: Middle Thickness Paper Mode
1. Power Supply Voltage Check when using before applying the final solution.
Check the Power Supply Voltage during the continuous printing.
SP1108-008 (Htg Roll Lamp2 Norm: FC)
Change to 100 (default: 83)
SP1108-009 (Htg Roll Lamp2 Scan: FC)
Change to 83 (default: 66)
07/04
