A SERVICE OF

logo

9-7
9. Software setup functions
Command
HD + SI + n
(1B,7C,60,02,00,0F,n)H
(17) Zoom in/out
(Setup Function #14)
n=00H 100% n=10H 200% n=1AH 1200%
01H 91%
02H 83% n=12H 400% n=1CH 1400%
03H 79%
04H 66% n=14H 600% n=1EH 1600%
0AH 116% n=16H 800%
0BH 120%
0CH 141% n=18H 1000%
This command specifies the zoom in/out in the currently
selected format memory.
HD + 4 + n
(1B,7C,60,02,00,34,n)H
(18) Paper fastener
(Setup Function #15)
n=0 NO
1 YES
This command specifies the paper fastener mode in the
currently selected format memory.
HD + ? + n
(1B,7C,60,02,00,3F,n)H
(19) Perforation head-up
(Setup Function #16)
n=0 NO
1YES
This command specifies the perforation head-up mode in
the currently selected format memory.
HD + Z + n
(1B,7C,60,02,00,5A,n)H
(20) Fanfold feed
(Setup Function #17)
n=0 FRICTION : NO
1 FRICTION : YES
This command specifies the fanfold feed in the currently
selected format memory.
Hexadecimal
Control code
Corresponding setup function
Code
See page 3-21.
See page 3-22.
See page 3-22.
See page 3-23.