CLI Commands B-37
■
Total time since system reboot (hours, minutes, seconds)
■ Total time since last linkdown:
■ Errored seconds since last link down:
■ Total errored seconds in 15 minutes:
■ Total errored seconds in previous 15 minutes:
show adsl
transceiver_status
Displays the current status of the ADSL/ATM link.
Fields:
■ Operational Mode: either “loss of signal” or “operational”.
■ Attenuation Upstream
■ Attenuation Downstream
■ Noise Margin Upstream
■ Noise Margin Downstream
■ Transmit Power (ATUR)
■ Transmit Power (ATUC)
■ Actual Negotiated Downstream Baud Rate:
■ Actual Negotiated Upstream Baud Rate:
show adsl version Fields:
■ ADSL hardware release version: 0x3530
■ ADSL Alcatel chipset firmware release version: 141
show bridge network
<name>
■ counters [Received Frames, Transmit Frames, Discarded]
■ settings [Interface, Network Address, Frame Type, Status, User Name,
Spanning Tree Enabled]
show bridge settings Displays the settings for all bridge networks. Use set bridge to modify these values.
■ Base Aging Time - time to age out a known MAC address, default 300
Parameters Description
counters Displays information about the specified bridge network. It lists:
Received Frames - packet frames which have been received
Transmit Frames - packet frames which have been sent
Discarded - packet frames which have been thrown away
settings Displays information about the specified bridge network. You use add bridge
network to define bridge networks.
Interface - the interface this bridge is using
Network Address - index number for this bridge network
Frame Type - BRIDGE is the default
Status - ENABLED or DISABLED are options
User Name - user to supply parameters for this bridge
Spanning Tree Enabled - ENABLED or DISABLED
