CLI Commands B-29
■
rip_flags [METRICS, SEND_REQUEST]
■ router_id [router_id]
Sets parameters for IP routing to the specified IP router address, which is the
gateway to an Autonomous System.
set ipx network
<network_name>
■ delay_ticks [number]
■ diagnostics [DISABLE | ENABLE]
■ maximum_learning_retries [number]
■ netbios [ENABLE | DISABLE]
■ netbios_name_cache [DISABLE | ENABLE]
■ netbios_cache_timer [seconds]
■ netbios_max_hops [number]
■ packet_maximum_size [number]
■ rip [BOTH | DISABLE | LISTEN | RESPOND_ONLY | SEND]
■ rip_age_multiplier [number]
■ rip_packet_size [number]
■ rip_update_interval [number]
■ sap [BOTH | DISABLE | LISTEN | RESPOND_ONLY | SEND]
■ sap_age_multiplier [number]
■ sap_packet_size [number]
■ sap_nearest_replies [ON | OFF]
■ sap_update_interval [number]
Sets parameters for the specified IPX network.
Parameters Description
autonomous_system_number Autonomous system number.
table_maximum_size Maximum number of IP routes system can hold in its table.
Default: 1000
metric_maximum_entries Most next hop entries the system table can maintain.
rip_flags Flags indicate at which level a RIP instance is disabled or
configured. Choices are:
METRICS - Specifies how to increment metrics using
RFC1058.
SEND_REQUEST - Sends a RIP request for routing information
when an interface first comes up.
Router_id The IP station address of the ip router.
Parameters Description
<network_name> Designation of the IPX network. Maximum size is 32 characters.
delay_ticks Interval in number of ticks it takes to reach this IPX network.
diagnostics Whether or not to send diagnostic packets to this IPX network.
maximum_learning_
retries
Number of times this network will resend packets to learn its directly
connected neighbors.
