B-22 APPENDIX B: CLI COMMAND DESCRIPTION
list users Lists all users, showing:
■ User Name - user designation you specified using add user
■ Login Service - The service used to login to the network (i.e. TELNET).
■ Status - link status: ACTIVE, INACTIVE or DISABLED
list vc Lists all virtual channel profiles, showing:
■ Name - user designation you specified using add vc
■ Network Service - type of network service: RFC1483, PPP, PPPLLC
■ VPI - Virtual Path Identifier
■ VCI - Virtual Channel Identifier
■ Status - link status: ACTIVE, INACTIVE or DISABLED
login_required enables or disables CLI password protection.
password The CLI password. It must consist of 1 to 8 alphanumeric (printable) characters,
inclusive.
PAUSED COMMANDS
PING
ping
<ip_name_or_addr>
■ output [output_filename]
■ count [count]
■ interval [interval]
■ timeout [timeout_value]
Sends an ICMP echo request to a remote IP host. A reply from the pinged address
indicates success.
QUICKVC Runs the QuickVC Setup program to easily configure a virtual channel connection
(remote site profile). See Chapter 5 for a complete description of the QuickVC
Setup program.
More (or CR) Continue printing
Quit Cancel rest of output
More (or CR) Continue printing
Parameters Description
<ip_name_or_address> IP address in dotted notation, or host name of remote system.
output A file name to direct output to.
count Number of ICMP echo requests to send.
interval Number of seconds to wait between sending each request.
timeout Number of seconds to wait for an echo response to return.
