Filter
Top Products
45 En
PREPARATIONINTRODUCTION APPENDIXPLAYBACK FEATURES SETTINGS
■ Remote control
■ iPod
ACQUIRING The signal is too weak. Adjust the orientation of the antenna of the
SiriusConnect tuner. Use the “Antenna Level”
information on the front panel display to check the
antenna reception level.
—
UPDATE The SiriusConnect tuner is updating the channel list. Wait until the updating is complete. —
The period of the subscription is end. Contact SIRIUS Satellite Radio to renew the
subscription.
27
FW UPDATING The SiriusConnect tuner is updating the firmware. Wait until the updating is complete. —
SUB UPDATED The subscription information is updated. — —
Problem Cause Remedy
See
page
The remote control does not work
and/or function properly.
Wrong distance or angle. The remote control functions within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
14
Direct sunlight or lighting (from an inverter type of
fluorescent lamp, etc.) is striking the remote control
sensor of this unit.
Reposition this unit.
—
The batteries are weak. Replace all batteries.
14
Cannot operate external
components with the remote
control of this unit.
The external component you want to operate is not
selected as the input source.
Press the desired DInput selector key to select the
external component you want to operate.
42
The remote control code was not correctly set. Set the remote control code correctly or try another
code for the same manufacturer using the “List of
remote control codes”.
42
Even if the remote control code is correctly set, there
are some models that do not respond to the remote
control.
Use the remote control supplied with the external
component.
—
Problem Cause Remedy
See
page
No sound. PDX-50TX is connected to another device. Select the same group ID as selected on this unit.
—
PDX-50TX and this unit are not connected since they
are set to different groups.
Set both PDX-50TX and this unit to the same group.
39
“Wireless Function” is set to “No”. Set “Wireless Function” to “Yes”.
39
Distance is too far. Move PDX-50TX closer to this unit.
—
There is a device (microwave oven, wireless LAN,
etc.) outputting signals in 2.4 GHz frequency band
nearby.
Move this unit away from the device. If the device is
IEEE802.11n-compliant, change the channel setting
of the device so as not to affect the unit.
—
The iPod or iPhone is not connected to PDX-50TX
firmly.
Connect the iPod or iPhone firmly.
—
The firmware of the iPod or iPhone is not updated. Download the latest iTunes software to update the
firmware of the iPod or iPhone.
—
The signal from PDX-50TX is blocked by your body
or metallic objects, etc.
Change the way of holding, orientation, or position of
PDX-50TX to avoid the object blocking the signal.
—
The battery of iPod or iPhone is low. Charge the iPod or iPhone.
—
The iPod or iPhone is in the process of connecting
with this unit.
Please wait for a while.
—
The protection circuitry has been activated by
excessive volume.
Turn down the volume.
21
Controlling volume on the iPod or
iPhone does not work.
The iPod or iPhone being used is not supported by
this unit.
Use an iPod or iPhone supported by this unit.
30
The iPod or iPhone is not connected to PDX-50TX
firmly.
Connect the iPod or iPhone firmly.
—
Status message Cause Remedy
See
page