Filter
Top Products
17 En
PREPARATIONINTRODUCTION APPENDIXPLAYBACK FEATURES
Changing OSD
language
AUTO SETUP
(IntelliBeam)
Using the system
memory
SETTINGS
2 Press G / to select “AUTO SETUP” and
then press GENTER.
3 Press G / to select “BEAM+SOUND
OPTIMZ”, “BEAM OPTIMZ ONLY” or “SOUND
OPTIMZ ONLY” and then press GENTER.
4 Prepare to leave the room.
The best setting may not be done if you are in the
room. Prepare to leave the room in 10 seconds after
pressing GENTER in step 5.
y
• Wait outside the room during the AUTO SETUP
procedure.
• The AUTO SETUP procedure takes about 3 minutes.
• To cancel the AUTO SETUP procedure after it is started,
press IRETURN.
5 Press GENTER to start the AUTO SETUP
procedure and then leave the room within 10
seconds.
The setup screen automatically changes during the
AUTO SETUP procedure.
If an error occurs, an error buzzer sounds and an error
message is displayed. For details on error messages,
see “Error messages for AUTO SETUP” (page 18).
If the AUTO SETUP procedure is complete, this unit
rings the chimes.
y
• If “ENVIRONMENT CHECK [FAILED]” is displayed,
refer to “Error messages for AUTO SETUP” (page 18),
press IRETURN, and then run the AUTO SETUP
procedure again.
• If “SUBWOOFER :NOT APPLICABLE” is displayed
even though a subwoofer is connected to this unit and
turned on, check the connection and then increase the
volume level of the subwoofer and run the AUTO SETUP
procedure again.
• Depending on the environment of your listening room, the
beam angles of front right and left and surround left and
right may be set to the same value even if “BEAM MODE
:5 BEAM” is displayed as a result.
6 Press GENTER to confirm the results.
The menu screen disappears in two seconds.
y
• If you do not want to reflect the results, press IRETURN.
7 Disconnect the IntelliBeam microphone.
The measurement results are stored in the internal
memory of this unit until you run the AUTO SETUP
procedure again or configure the settings manually.
1)BEAM+SOUND OPTIMZ
2)BEAM OPTIMZ ONLY
3)SOUND OPTIMZ ONLY
[ ]/[ ]:Up/Down
[ENTER]:Enter
B)AUTO SETUP
p
p
PREPARATION & CHECK
Please connect the MIC.
Please place the MIC at least
1.8m/6ft away from the unit.
The MIC should be set
at ear level when seated.
Measurement takes about 3min.
After [ENTER] is pressed,
please leave the room.
[ENTER]:Start [RETURN]:Cancel
AUTO SETUP
Will begin in 10sec
Please leave the room
**--------
[RETURN]:Cancel
AUTO SETUP START
MEASUREMENT COMPLETE
BEAM MODE :5Beam/Plus2
SUBWOOFER :YES
[ENTER]:Save set-up.
[RETURN]:Do not save set-up.
XXXXXXXXSHOW RESULTXXXXXXXXXX
AUTO SETUP COMPLETE
Please remove the MIC from
the unit and the listening
position.
INPUT VOLUME INTELLIBEAM MIC