Filter
Top Products
18 En
■ Error messages for AUTO SETUP
If an error message is displayed on your TV, check the error message list to solve the problem and then follow the
procedure below.
[ERROR E-1]: Press GENTER to run the AUTO SETUP procedure again or IRETURN to cancel the operation
Other errors: Press IRETURN to cancel the operation and then run the AUTO SETUP procedure again.
Note
If the problem is difficult to be solved, configure the settings manually in “MANUAL SETUP” (page 34).
Error message Cause Remedy
See
page
ERROR E-1
Please test in quieter environment.
There is too much unwanted noise in
your listening room.
Make sure that your listening room is as
quiet as possible. You may want to
choose certain hours during the day
when there is not much noise coming
from outside.
—
ERROR E-2
No MIC detected. Please check
MIC connection and re-try.
The IntelliBeam microphone is not
connected to this unit or disconnected
during the AUTO SETUP procedure.
Connect the IntelliBeam microphone to
this unit firmly.
15
ERROR E-3
Unexpected control is detected.
Please re-try.
Some other operations were performed
on this unit while the AUTO SETUP
procedure was in progress.
Do not perform any other operations
while the AUTO SETUP procedure is in
progress.
—
ERROR E-4
Please check MIC position. MIC
should be set in front of the unit
and re-try.
The IntelliBeam microphone is not
placed in front of this unit.
Make sure that the IntelliBeam
microphone is installed in front of this
unit.
15
ERROR E-5
Please check MIC position. MIC
should be set above 1.8m/6.0ft and
re-try.
The IntelliBeam microphone is not
placed in the right distance from this
unit.
Make sure that the IntelliBeam
microphone is installed more than 1.8 m
(6.0 ft) from the front of this unit and
within 1 m (3.3 ft) from the center height
of this unit.
15
ERROR E-6
Volume level is lower than
expected. Please check MIC
position/connection and re-try.
The IntelliBeam microphone cannot
collect the sound produced by this unit
because the sound output level is too low.
Make sure that the IntelliBeam
microphone is firmly connected to this
unit and placed in a proper location. If
the problem persists, contact the nearest
authorized Yamaha service center for
assistance.
15
ERROR E-7
Unexpected error happened.
Please re-try.
An internal system error occurred. Repeat the AUTO SETUP procedure.
—
0 +10
ENT
7 8 9
4 5 6
1 2 3
HDMI 4 iPod RADIO
ENTER
SURROUND STEREO
OFF
ENTER
TAINMENT
MUSIC
CINEMA DSP
MOVIE
HDMI 1 HDMI 2 HDMI 3
TV AUX 1 AUX 2
TV AV
MENUTOP MENU
OPTION
TV
MUTE
CODE SET
UNIVOLUME SUR. DECODE INTELLIBEAM
TV
INPUT MUTE
TV VOL CH VOLUME
SETUP RETURN
MEMORY
SLEEPINFO
TUNING PRESET CATEGORY
OPTION SETUP RETURN
I
ENTER
G
GENTER
G /
IRETURN
ISETUP