Filter
Top Products
44 En
■ FM tuner
■ SIRIUS Satellite Radio
Problem Cause Remedy
See
page
Surround sound effects are
insubstantial.
The listening room is not a regular shape. Install this unit in a square or rectangular shaped
room.
—
There is no wall in the path of the sound beam. Try placing a flat object, such as a board, in the path
of the sound beam.
—
Digital audio signals cannot be
played back. (q DIGITAL indicator
does not light up in the front panel
display.)
The playback component is connected to this unit
with an analog connection.
Connect them with an HDMI connection or a digital
connection.
12
The external component is not set to output digital
audio signals.
Refer to the owner's manual supplied with your
component and check the setting.
—
Bit streaming is disabled on the external component. Refer to the owner's manual supplied with your
component and check the setting.
—
There is noise interference when a
subwoofer is not connected to this
unit.
The protection circuitry was in operation because a
source with strong bass elements was played back.
Turn down the volume level.
21
Set “BASS OUT” to “SUBWOOFER” in
“SUBWOOFER SET”.
36
Connect a subwoofer and adjust settings for
“SUBWOOFER SET”.
36
On-screen display does not
appear.
The cable is not connected to the TV or this unit
properly.
Connect the cable properly.
12
The HDMI control function does
not work properly.
“HDMI CONTROL” is set to “OFF” in “SET
MENU”.
Set “HDMI CONTROL” to “ON” in “SET MENU”.
39
The HDMI control function is disabled on your TV. Refer to the owner's manual supplied with your TV
and check the setting.
—
The number of the connected HDMI components is
over the limit.
Disconnect some of the HDMI components.
—
The automatic lipsync is not
effective even “AUTO LIP SYNC” is
set to “ON”.
The TV does not support the automatic lipsync. Set “AUTO LIP SYNC” to “OFF” and then manually
adjust the audio output delay.
36
“Not Available” appears on the
front panel display after key
operation.
The key is unable to function in the current condition. —
Problem Cause Remedy
See
page
FM stereo reception is noisy. The characteristics of FM stereo broadcasts may
cause this problem when the transmitter is too far
away or the antenna input is poor.
Check the antenna connections.
14
Try using a high-quality directional FM antenna.
—
Use the manual tuning method.
25
There is distortion, and clear
reception cannot be obtained even
with a good FM antenna.
There is multi-path interference. Adjust the antenna position to eliminate multi-path
interference.
—
The desired station cannot be
tuned into with the automatic
tuning method.
The signal is too weak. Use a high-quality directional FM antenna.
—
Use the manual tuning method.
25
Previously preset stations can no
longer be tuned into.
This unit has been disconnected for a long period. Preset the stations again.
25
Status message Cause Remedy
See
page
ANTENNA ERR The antenna is not connected to the SiriusConnect
tuner properly.
Check the connection of the antenna and
SiriusConnect tuner.
26
SIRIUS LOADING This unit is communicating with the SiriusConnect
tuner.
The message disappears normally within several tens
of seconds.
—
CHECK TUNER The SiriusConnect tuner is not connected to the
SIRIUS jack of this unit correctly.
Check the connection of the SiriusConnect tuner and
this unit.
26
The SiriusConnect tuner is not connected to the AC
wall outlet.
Connect the power cable of the SiriusConnect tuner to
the AC wall outlet.
26