Filter
Top Products
45
REMOTE CONTROL FEATURES
ADVANCED
OPERATION
Once you set the appropriate remote control codes, you
can use this remote to control your other components.
Note that some buttons may not correctly operate the
selected component. Use the input selector buttons to
select the component you want to operate. The remote
control automatically switches to the appropriate control
mode for that component.
■ Default codes
The following table shows the default component
(Library: component category) and the remote control
code for each area.
You may not be able to operate your YAMAHA component even
if a YAMAHA remote control code is initially set as listed above.
In this case, try to set another YAMAHA remote control code.
■ Setting a code
1 Hold down CODE SET while doing steps 2
and 3.
2 Press an input selector button to select the
source component you want to set up.
3 Press the numeric buttons to enter the three-
digit remote control code for the component
to be used, then release CODE SET.
Refer to “LIST OF REMOTE CONTROL CODES” at the
end of this manual.
y
To reset an input area’s remote control code to the factory default,
input the default code (see “Default codes” above) in step 3.
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• If you wait for more than 10 seconds during step 3, the setup
process is canceled. If this happens, start over from step 2.
• Replace the batteries frequently. The settings may be lost after
two minutes without power supply.
• If the remote control code is successfully set, “Code Set OK”
appears in the front panel display of this unit. If the setting is
not successful, “Code Set NG” appears.
Setting remote control codes
Input area Manufacturer Code
TV (DTV/CBL) YAMAHA 299
VCR YAMAHA 399
DVD (DVD/CD) YAMAHA 699
Note
CODE SET
VCRDVD/CD VIDEO 1
TUNERDTV/CBL VIDEO 2
Notes
1
STEREO
2
HALL
3
JAZZ
4
ROCK
5
MUSIC
6
ENTERTAIN
7
TV THTR
8
MOVIE
9
STANDARD
0
NIGHT
+10
EXTD SUR.
ENT
STRAIGHT
EFFECT