Yamaha HTR-6090 Stereo Receiver User Manual


 
RECORDING
74 En
Recording adjustments and other operations are performed from the recording components. Refer to the operating
instructions for those components.
The DTS signal is a digital bitstream. Attempting to digitally record the DTS bitstream will result in
noise being recorded. Therefore, if you want to use this unit to record sources encoded in DTS, the
following considerations and adjustments need to be made. To play DTS-encoded DVDs and CDs
(when using a digital audio connection) on your DTS-compatible player, follow its operating
instructions to make a setting so that the analog signal will be output from the player.
When this unit is set to the standby mode, you cannot record between other components connected to this unit.
The settings of TONE CONTROL (see page 49), VOLUME, the speaker level (see page 89) and the sound field programs (see
page 44) do not affect recorded material.
The source connected to the MULTI CH INPUT jacks of this unit cannot be recorded.
The XM Satellite Radio signals cannot be output at the AUDIO OUT (REC) jacks.
Digital signals input at the DIGITAL INPUT jacks are not output at the analog AUDIO OUT (REC) jacks for recording. Likewise,
analog signals input at the AUDIO IN jacks are not output at the DIGITAL OUTPUT jack. Therefore, if your source component is
connected to provide only digital or analog signals, you can only record digital or analog signals.
A given input source is not output on the same OUT (REC) channel.
S-video and composite video signals pass independently through the video circuits of this unit. Therefore, when recording or dubbing
video signals input from a video source component that provides only an S-video or a composite video signal, you can record only an
S-video or a composite video signal on your VCR.
The analog audio signals input at the DOCK terminal can be output at the analog AUDIO OUT (REC) jacks for recording.
Check the copyright laws in your country to record from CDs, radio, etc. Recording of copyrighted material may infringe copyright
laws.
y
Do a test recording before you start an actual recording.
1 Turn on all the connected components.
2 Rotate the INPUT selector on the front panel
(or press one of the input selector buttons on
the remote control) to select the source
component you want to record from.
3 Start playback on the selected source
component or select a broadcast station.
4 Start recording on the recording component.
RECORDING
Notes
If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture
itself may be disturbed due to those signals.
CAUTION
INPUT
VOLUME
MAIN ZONE
ZONE 2
ZONE 2
CONTROLS
ON/OFF
ENHANCER
SILENT CINEMA
NIGHT
PHONES
OPTIMIZER MIC
MASTER
ON
OFF
PURE DIRECT STRAIGHT
EFFECT
PROGRAM
TONE CONTROL
AUDIO SELECT
INPUT
ZONE 2
ZONE 2 VOLUME
PRESET/TUNING
FM/AM
SEARCH MODE
EDIT
A/B/C/D/E
CATEGORY
PRESET/TUNING/CH
MEMORY
TUNINIG MODE
DISPLAY
MAN'L/AUTO FM
VIDEO AUX
S VIDEO
VIDEO
AUDIO
L
R
OPTICAL
INPUT
ON/OFF
2
V
-
AUX/DOCK
AV
TV
DTV
DVR/VCR 2
VCR 1
DVD
CBL/SAT
MD/TAPE
CD-R
PHONO
TUNER CD
MULTI CH IN
SLEEP
AUDIO SEL
POWER
POWER
POWER
STANDBY
XM
2
INPUT
V
-
AUX/DOCK
DTV
DVR/VCR 2
VCR 1
DVD
CBL/SAT
MD/TAPE
CD-R
PHONO
TUNER CD
or
Front panel Remote control
01EN_00_HTR-6090_U.book Page 74 Tuesday, June 27, 2006 6:40 PM