Yamaha HTR-6090 Stereo Receiver User Manual


 
113 En
USING MULTI-ZONE CONFIGURATION
ADVANCED
OPERATION
Using the internal amplifiers of this unit
Connect the Zone 2 speakers directly to the SP1 speaker terminals and select “[SP1]” for “ZONE2 AMP” (see page 99).
You can select Zone 2 by using the control buttons on the
front panel or on the remote control.
Selecting Zone 2
Front panel operations
1 Press ZONE 2 ON/OFF on the front panel to
individually turn on or off Zone 2.
y
Once MASTER ON/OFF on the front panel is pressed
inward to the ON position, you can also press POWER and
STANDBY on the remote control to turn on the main zone
and Zone 2.
2 Press ZONE 2 CONTROLS on the front panel
to activate the Zone 2 control mode.
While this unit is in the Zone 2 control mode, the
ZONE2 indicator flashes.
In the Zone 2 control mode, you can perform the
following operation in Zone 2.
Adjusting the tonality of Zone 2
Adjusting the balance of the speaker level in Zone 2
AM, FM or XM Satellite Radio tuning in Zone 2
y
This unit automatically exits the Zone 2 control mode after
approximately 5 seconds from the last operation is
performed.
See page 115 for details about the Zone 2 input select
mode.
See page 115 for details about the Zone 2 volume control
mode.
IMPORTANT SAFETY NOTICE
The SP1 speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or more
than one loudspeaker per channel.
Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low
impedance load resulting in amplifier damage. See this owner’s manual for correct usage.
Compliance with minimum speaker impedance information for all channels must be maintained at all times. This
information is found on the back panel of your Receiver.
SINGLE
R
L
+
+
+
+
BI-AMP
SURROUND BACK/
PRESENCE
R
L
SP1
This unit
Second room
(Zone 2)
Controlling Zone 2
ZONE 2
ON/OFF
ZONE 2
CONTROLS
ZONE2
Flashes
01EN_00_HTR-6090_U.book Page 113 Tuesday, June 27, 2006 6:40 PM