Yamaha HTR-6090 Stereo Receiver User Manual


 
99 En
CUSTOMIZING THIS UNIT (MANUAL SETUP)
ADVANCED
OPERATION
Zone set F)ZONE SET
Zone 2 volume ZONE2 VOL
Use to select how the volume control will operate with
regard to the ZONE 2 OUTPUT jacks.
Choices: VAR, FIX
Select “VAR” to adjust the ZONE 2 OUTPUT volume
simultaneously with VOLUME +/– on the remote
control.
Select “FIX” to fix the ZONE 2 OUTPUT volume level
to a standard line level.
Zone 2 amplifier ZONE2 AMP
Use to select how the ZONE 2 speakers are amplified.
Choices: EXT, [SP1]
Select “EXT” if you want to connect your Zone 2
speakers through an external amplifier connected to the
ZONE 2 OUTPUT jacks on the rear panel of this unit.
Select “[SP1]” to use the internal surround back
amplifier of this unit when you want to connect your
Zone 2 speakers directly to the SP1 speaker terminals
on the rear panel of this unit.
When “BI-AMP” is set to “ON” in the “ADVANCED SETUP”
menu, “[SP1]” cannot be selected.
When you use internal amplifiers for Zone 2, some surround
field programs may not work in the same way as when you do
not use the internal amplifiers for Zone 2.
XM Radio setting G)XM RADIO SET
XM Radio antenna XM ANTENNA
Use this feature to check the current reception level of the
XM Passport System connected to the XM jack of this
unit (see page 60). For the best reception, orient the XM
Passport System so that a value of 60% or more is
displayed here.
Display status: NONE, 0 to 100%
“NONE” is displayed if the XM Passport System is not connected to
this unit. In this case, check the antenna connections (see page 60).
The “XM ANTENNA” parameter cannot be adjusted by using
the remote control. Instead, you need to adjust the orientation of
the XM Passport System connected to the XM jack of this unit
for a better percentage of the reception level.
Dock set H)DOCK SET
Charge on standby STANDBY CHRG
Use this feature to select whether this unit charges the
battery of the stationed iPod or not when this unit is in the
standby mode (see page 72).
Choices: AUTO, OFF
Select “AUTO” to charge the battery of the stationed
iPod when this unit is turned on and in the standby
mode.
Select “OFF” to charge the battery of the stationed
iPod only when this unit is turned on.
Notes
. ZONE2 VOL;;;;VAR
ZONE2 AMP;;;;EXT
F)ZONE SET
[]/[]:Up/Down
[]/[]:Adjust
p
p
[p
Notes
G)XM RADIO SET
.XM ANTENNA;;NONE



H)DOCK SET
.STANDBYCHRG;AUTO

[]/[]:Adjust
[ENTER]:Return
)
)
01EN_00_HTR-6090_U.book Page 99 Tuesday, June 27, 2006 6:40 PM