Filter
Top Products
13 En
CONNECTIONS
PREPARATION
Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) properly. If the connections are faulty,
no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be
unnatural and lack bass.
• Before connecting the speakers, make sure that this unit is turned off (see page 30).
• Do not let the bare speaker wires touch each other or do not let them touch any metal part of this
unit. This could damage this unit and/or speakers.
• Use magnetically shielded speakers. If this type of speaker still creates interference with the
monitor, place the speakers away from the monitor.
• If you are to use 6 ohm speakers, be sure to set “SP IMP.” to “6ΩMIN” before using this unit (see
page 29). 4 ohm speakers can be also used as the front speakers (see page 118).
• A speaker cord is actually a pair of insulated cables running side by side. Cables are colored or shaped differently, perhaps with a
stripe, groove or ridge. Connect the striped (grooved, etc.) cable to the “+” (red) terminals of this unit and your speaker. Connect the
plain cable to the “–” (black) terminals.
• The low-frequency signals of other speakers set to “SML” (or “SMALL”) or to “NONE” in “SPEAKER SET” (see pages 86 and 88)
are directed to the speakers selected in “LFE/BASS OUT” (see page 86).
• You can connect both surround back and presence speakers to this unit, however they do not output sound simultaneously. You can set
to prioritize either set of speakers using the “PRIORITY” parameter in “MANUAL SETUP” (see page 88).
• You can use the PRESENCE terminals to connect the Zone 2 speakers as well as the presence speakers (see page 112).
Connecting speakers
Notes
CAUTION
SPEAKERS
CENTER
BI-AMP
SURROUND BACK/
PRESENCE
FRONT
SURROUND
SINGLE
PRE OUT
SUB
WOOFER
+
+
+
+
+
+
+
+
+
R
L
R
L
R
L
SP1
Front speakers
Surround speakers
Presence speakers
Subwoofer
Right
Left
Left
Center speaker
Surround back speakers
Right
Left
Left
Right
Right
01EN_00_HTR-6090_U.book Page 13 Tuesday, June 27, 2006 6:40 PM