Open as PDF
Make sure the FM and AM antennas are connected to this
■ Tuning radio stations
1 Press TUNER to select “TUNER/FM” or “TUNER/
2 Press / briefly on the remote control.
→ “SEARCH” appears.
→ The next radio station is tuned automatically.
3 Repeat step 2 (if necessary) until you find the desired
4 To tune weak stations, press / briefly and
repeatedly until the optimal reception is found.
If the FM station reception is weak, you can switch the
FM mode from stereo to mono. Press SURR to toggle
DOLBY PL II FM STEREO
→ DOLBY PL II FM MONO
→ STEREO FM MONO
→ STEREO FM STEREO
(U.K. and Europe models only)
While receiving an FM station, the name of the station
you selected appears in the system display panel.
■ Presetting radio stations
You can store up to 20 FM and 10 AM preset radio
stations in this receiver’s memory.
– The receiver will exit presetting mode if no button
is pressed within 20 seconds.
– If no valid frequency is detected during Plug and
Play, “CHECK ANTENNA” appears.
Using Plug and Play
Plug and Play allows you to store all available radio
1 Press TUNER.
→ “AUTO PRESET” and “PRESS PLAY” appear one
after the other if installation was not completed after
you purchased the DVD receiver.
2 Press on the front panel to start installation.
→ “AUTO PRESET” appears.
→ Once complete, the last tuned radio station will
→ All available FM stations are stored, followed by
all available AM stations.
To stop installation
You can start automatic presetting by pressing a selected
1 Press TUNER to select “
TUNER/FM” or “TUNER/
2 Press b / a or use the numeric keypad (0-9)
to select a preset number to begin.
TV VOL TV CH
SUBTITLE AUDIO ANGLE ZOOM
TV AUX TUNER DVD/CD
REPEAT A - B
(b / a)