Filter
Top Products
Restoring Defaults
37
.
www.velodyne.com
Digital Drive User’s Manual
B
y pressing the SELECT button, you tell the system to save your settings and return to the
introduction screen. Selecting NO returns without saving (i.e. whatever previous settings were
i
n effect will be used), and CANCEL keeps you in setup mode.
When the unit saves settings, you will see the video flicker and you may hear a slight tick in your
main speakers. This is normal behavior.
NOTE: The Digital Drive subwoofer stores all of its settings in internal “Flash” memory. This
memory persists even if the woofer is turned off, loses power, or undergoes a programming
update, so you need not worry about losing your customized settings.
There is a feature in Digital Drive that allows you to restore the factory defaults. On the Main
Screen, simply press the 8, 9, and 0 buttons in sequence. If you are successful, the unit will
flicker the video and then restore the main screen. The system responds with a defaults
restored message, as shown below: