Filter
Top Products
Concerning the Remote Control
Battery installation
2
fl Openthe ] f/'_ Insertthe I ft'_ Cl°sethe]
Be sure that you insert the batteries so that their positive (+)
Open the cover, and negative (-) polarities match the polarities indicated in
Press gently and slide the cover out. the compartment. Batteries installed with incorrect polarities
may leak and damage.
Insert the batteries Included with this unit.
When you need to replace these batteries, use two UM-4 AAA,
IEC R03 (1.5 V) or equivalent batteries.
Refer to "Use of batteries" for additional information.
3 c,o,ethe cover.
Use of batteries
Do not try to mix old and new batteries or batteries of different
types (carbon and alkaline, etc.).
If you will not use the remote control for a long period of time,
remove the batteries and store them in a cool, dark place.
Always remove old, weak or worn-out batteries promptly and
dispose of them properly.
The average battery life is about one year. Although the battery life
varies depending on how often the device is used, you should
generally replace the batteries about once a year.
If a battery leaks, remove all batteries and dispose of them proper-
ly. Thoroughly clean the battery compartment before inserting new
batteries. If the leaking electrolyte comes into contact with skin or
clothes, flush with water immediately.
Keep batteries out of reach of children.
Replace the batteries if commands from the remote control
transmitter do not operate the unit even when the transmitter is
held close to the front panel.
Do not use rechargeable type (nickel-cadmium) batteries.
Do not attempt to recharge alkaline or carbon batteries.
Never subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure they are not short-circuited.
Operation notes
(_) Aim the remote control transmission window toward the
changer's sensor. Avoid any obstacles.
B
_Avoid d
(_) Be sure the transmission window and the changer's sensor are
free from dust. Excessive dust might prevent reception.
(_) Use the remote control within a 60-degree angle of the
changer.
The reachable distance is within 7 meters (23 ft.) directly facing
toward the changer.
If direct sunlight or other strong lightsources strike the remote con-
trol signal sensor of the changer, operation may be impaired. If
there is a problem, place the changer away from the light source.
5