Filter
Top Products
Troubleshooting Guide
Before requesting service for this unit, check the chart below for a
possible cause of the problem you are experiencing. Some simple
checks or a minor adjustment on your part may eliminate the pro-
blem and restore proper operation.
If you are in doubt about some ol the check points, or if the
remedies indicated in the chart do not solve the problem, refer to
the directory of authorized service centers (enclosed with this unit)
to locate a convenient service center, or consult your Technics
dealer for instructions.
(In U.S.A. consult MSC Authorized Servicenters for detailed instruc-
tions.)
I
Problem
Probable cause(s)
Suggested remedy
I
Changer will not play.
The disc In the changer
does not play.
A certain music passage
can't be played correctly.
These is noise from the
tuner or disturbance on the
TV screen.
When program play is
started, an error message
(-E) appears on the
display.
An error message (-E)
appears on the display, and
the changer stops
operating.
The loading drawer stops in
the middle of opening.
Remote control does not
operate correctly.
The disc(s) or other foreign object(s) has fallen
inside of the changer.
Moisture has condensed in the changer.
The disc is upside down.
The disc is dirty.
The disc is scratched.
The disc is warped.
The disc is not within specified standards.
The disc is dirty.
The disc is scratched.
Caused by high-frequency signals of this changer.
Playback was started without a track being
programmed.
The mechanism of the changer has been
improperly adjusted.
• Open the loading drawer, then remove the object.
• Switch ON and allow the changer to dry out for
about one hour before using the changer.
• Be sure the label is facing upward.
• Wipe it with a soft cloth.
• Replace the disc with a new disc.
• Exchange the disc for another one.
• Wipe the disc with a soft cloth.
• Replace the disc with a new one.
• Use the changer farther away from the tuner or
TV.
• If the tuner's or TV's antenna is the indoor type,
use an outdoor one.
• Program a track.
• Turn the power switch OFF and then back ON
again.
However, if the loading drawer is fully open, take
out the compact discs (1 or 2) and then turn the
power switch OFF and then back ON again.
The batteries are dead. • Replace batteries with new ones.
There is an obstruction between the remote • Remove the obstruction.
control and the changer.
The batteries are inserted incorrectly. • Reinsert batteries so that the polarities are cor-
[The (+) and (-) polarities are reversed.] rect.
Product Service
Do not attempt to remove the cover(s) or repair the unit yourself.
Refer servicing to qualified personnel only.
Product information
For product service, product information or assistance in product
operation, refer to the servicenter directory.
39