Filter
Top Products
CD Edit-Recording ,oo.,,.uo°,
If Prepare the / /_ TAPE LENGTH / Iz-!- I _,_ 1
tracks from the | / cassette deck for/ / / /
desired discs. J L recording. J ___ _ J _
34
Prog ra rn.edit.re cord ing
Editing of the selections which you have programmed among the
five discs is available.
Note that you cannot get the information regarding the number of
tracks that will be recorded and the remaining time on side A and B
as in the "Sequential-edit-recording".
Before operation, follow the steps 1-4 of "Basic
Operating Procedure" on page 9.
Enter the desired disc numbers and track
numbers following the programming pro-
cedure.
(See pages 14- 17.)
For example:
When using a 46-minute tape, you should calculate the total
programming time to be recorded (including the 3-seconds
silent gap) for each tape side A/B (23 minutes) and program
the selections accordingly.
The changer can edit up to 32 selections.
2
Prepare the cassette deck for recording.
1. Insert the cassette tape into the cassette holder of the
deck for the synchro edit recording. (Be sure the tape is re-
wound.)
2. Select the noise-reduction system and the reverse mode
(c-'_).
3. Check to be sure that the forward-side indicator (1_) of the
deck to be used is illuminated.
4. Press PLAY of this changer.
5. Set the cassette deck on the recording standby mode.
6. Adjust the recording level.
7. Press STOP of this changer.
(Refer to the operating instructions for the cassette deck.)
3
Press TAPE LENGTH to select the
length.
(See step 3 on page 32.)
For example, if you use a 46-minute tape:
The disc number programmed first
I
I <1"<2"_" '31p:'4"<5" "/ }-- - IJ5 I--I /._
PGM_ _ . B)fl'll msc MIN
I--1"1"71t--/ I
SEC
4_
tape
I (1 J,<2):<.'_:.4_. <_) _7
. PGM. . . EDffll o=_I
The maximum allowable playing time for editing is 99 minutes.
4 Press PLAY.
Recording will begin from side A.
When the tracks programmed for tape side A have finished playing,
the changer switches to the pause mode at the beginning of the
first track for side B. When the auto reverse mechanism of the
cassette deck works at the end of side A and the tape switches to
side B, recording for side B starts automatically.
Depending on the disc, a little sound of the beginning of the next
track may be recorded onto the end of the track.
To stop recording
Press STOP and then press the stop button on the
cassette deck.