Filter
Top Products
30
Settings (System)
Subwoofer Setting
“SW+” mode is valid only when “FRONT” and “CENTER” are
set to “L” and “SUB-W” to “Y” on the SPK SET menu. For
details, refer to “Speaker Setup” on page 31.
NORM (default):
The low frequency signals of channels set to “L” are
reproduced from those channels only.
In this mode, the low frequency signals that are produced
from the subwoofer channel are only the LFE signals (from
the multi-channel sources that contain LFE (Low Frequency
Effects) channel, also called the “0.1” channel) and the low
frequency signals of the channels set to “S”.
SW+:
The low frequency signals of channels set to “L” are
produced simultaneously from those channels and the
subwoofer channel.
In this mode, the low frequency range expands more
uniformly through the room, but depending on the size and
shape of the room, interference may result in a decrease of
the actual volume of the low frequency range.
TONE CONTROL
Press the SELECT button (5 or b) to select the desired tone,
then press the SELECT button (
g or t) to adjust the selected
tone as desired.
When the tone control is set to off, the “DIRECT” indicator
lights on the display and you can listen to a program source
without the tone effect.
When the tone control is set to on, the “DIRECT” indicator
turns off and you can adjust the tone for your taste.
< In general, we recommend the bass and treble to be adjusted
to 0 dB (flat level).
< Extreme settings at high volume may damage your speakers.
Press the SELECT button (
5 or b) to select the desired input
source, then press the ENTER button. Press the SELECT button
(
5 or b) to select the desired item, then press the SELECT
button (
g or t) to set the selected item as desired.
D.IN (DIGITAL IN):
You can select from OPT (optical), COX 1 (coaxial 1 - default),
COX 2 (coaxial 2) and ANL (analog).
< You can hear the sound from the selected DIGITAL IN
terminal, as far as VIDEO (1 or 2) or CD has been selected.
AUTO (AUTO SURROUND):
When you select “ON”, the optimum surround mode will be
automatically selected depending on the signal format being
input.
When you select “OFF” (default), you can select from
different surround modes available for the signal being input
using the SURROUND buttons ( / ).
< When the SPEAKER ON/OFF button is set to OFF, the AUTO
SURROUND mode is invalid.
< Even when the AUTO SURROUND mode is selected and the
same type of digital signal format is being input, the optimum
surround mode may vary depending on whether the speaker
type is set to “N (None or No)” or not.
< When the AUTO SURROUND mode is selected, the surround
modes other than the optimum surround mode cannot be
selected. When the AUTO SURROUND mode is selected and
the PCM (2 channel) digital signal or the analog stereo signal
is being input, only the stereo mode will be selected.
< When 96 kHz PCM signal is being input, only the stereo
mode will be selected regardless of selecting either the auto
surround mode or the manual surround mode.
Settings (Input)