Filter
Top Products
1- Introduction
TASCAM CC-222SL 33
Error messages
Message Details / Response
Cannot Rec! Use unfinalized recordable disc.
Disc Error! The unit may ejects the loaded disc. If it is CD-RW disc, you may refresh it
(“Refreshing a disc” on page 28), or replace disc.
Disc Full !! There is no space on disc, or no tracks are available.
Drive Error! There is problem with the Drive mechanism.
D-IN UNLOCK! Digital input is not connected. Turn on power of source unit and
connect to DIGITAL IN.
Cannot ERASE! The data cannot be erased.
Erase Error! An error has occurred while trying to erase disc.
Not Fs 44.1k! The sampling frequency of digital input is not 44.1kHz.
Please turn SRC on (“Frequency conversion” on page 20).
PGM Full ! An attempt has been made to create more than 99 tracks.
Rec Error A general recording error. Try recording again with different disc.
The unit may ejects the loaded disc.
System Err! System Error. Try turning the power off and on again.
Eject Error! There is a problem with the disc slot.
Messages displayed during normal operation
Message Statement
Complete An operation such as finalize or erase has been successfully completed.
Now OPC Calibration is being performed to operate recording properly.
Now REPAIR The disc is being repaired and this operation will take a long time.
Please do not turn off power of the unit until it finishes.
PMA Writing Recorded content is being written to disc.
TOC Reading Table of contents data is being read.
REC Standby The unit is in recording standby mode.
Blank Disc A blank recordable disc has been inserted.
NO DISC A disc is not loaded into the unit.
8 – Reference and specifications