1- Introduction
TASCAM CC-222SL 31
7 – Cassette operating
Dubbing to tape from the middle of a CD
The above procedure describes the playback and recording
from the start of a disc (or the start of a programmed play-
back list).
To record from a point other than the ones above:
1 Locatethedisctothepointwheretheplaybackisto
start.
2 PressthediscPAUSEkeytopauseplaybackatthe
pointwheretheplaybackistostart.
3 Ifrecordingistostartatthebeginningofthecas-
sette,makesurethecassetteisstopped,otherwise,
locatethecassettetotheappropriatepositionwhere
recordingistostart,andenterrecordstandby
mode.
UsingtheheadphoneswiththeMONITORswitchset
to MIXwillhelphere.
4 PresstheDUB 2key.Playbackstartsonthedisc,
andrecordingstartsonthecassette.
Recording tapes from the PHONO deck
To record from an external record deck connected through
the RIAA PHONO inputs:
1 Prepareforrecordingasdescribedabove(loada
tape,settheREVMODE,etc.).
2 PresstheMENUkeyuntilthePHONO>XXX
menuitemisshown.
TurningtheMULTI DIALorpressingtheSKIPkeys
ontheremotecontroltoselecteitherTAPE.
PresstheMULTI DIALorENTERontheremotecon-
trolunit.
3 PressthePHONOkey.ThePhONOindicatorlightson
thedisplay.
Ifthetapeiscurrentlyinstopmode,thetapere-
winds,andthedeckentersrecordstandbymode
(abouteightsecondsfromthestartofthecassette,
toallowforleadertape).
Ifthetapedeckisalreadyinrecordstandbymode,
itwillremaininrecordstandbymode.
4 Startplaybackoftherecord.
5 StartrecordingwitheitherthePLAYorPAUSEkey.
PressSTOP(cassettedeck)tostoptherecording.
The STOPkeyistheonlykeywhichisenableddur-
ingphonorecording.
NOTE
It is not possible to perform phono recording as
described above under the following circumstances:
a tape is not loaded or the tape is write-protected (the
phono to tape function is disabled with no recordable
tape inserted), or the tape is not either stopped or in
record standby mode.
Only recording as described above is possible from
the RIAA PHONO sources to tape. Manual recording is
not possible.
Erasing tapes
Anything previously recorded on the tape will automatical-
ly be erased when you make a new recording on it. It can
also be erased by “recording” on it with the INPUT level
control set to “0”.
Other recording features
Recording silences between items
At least four seconds of silence must be recorded between
items on tape when using the search functions (see “Search
keys” below).
When recording, press and release either of the REC
MUTE keys (main or remote). With the tape moving, the
record source is muted for about four seconds (the display
record indicator flashes), and the deck then enters record
pause mode. Press PAUSE or PLAY to re-start recording.
If the REC MUTE key is pressed while the deck is in
record standby mode, four seconds of silence will be
recorded on the tape, and the deck will return to record
standby mode.
If the REC MUTE key is held and pressed for longer than
four seconds while recording is in progress, silence is
recorded on the tape while the key is held down. The deck
enters record standby mode when the key is released.