Filter
Top Products
1- Introduction
10 TASCAM CC-222SL
Do not expose the infrared receiver (light receptive area
on the front panel) to direct sunlight or intense light for
extended periods of time. Long exposure to this light
may result in failure of the remote control sensor.
When the remote control will not be used over one
month, please remove the batteries to prevent the possi-
bility of battery acid leakage which could damage the
unit. Should leakage occur, remove and discard the
batteries, and wipe the battery case thoroughly with a
cloth. Avoid getting the battery liquid on the skin. After
cleaning, replace with new batteries.
The remote control functions by using an infrared light
signal. When using the unit to control the CC-222SL, other
devices that are turned on could be operated by its signal.
•
•
•
If the range of remote operation becomes smaller, or
commands do not always function properly, the batter-
ies have become weak and should be replaced. Always
replace both batteries with new batteries of the same type.
Point the remote control to the remote sensor on the
main unit. Do not obstruct the path between the remote
control and the remote sensor.
•
•
Use of the remote control unit
If batteries are used improperly, or if leakage or breakage
occurs, the unit will not function.
Please observe the cautions indicated on the batteries and
their packaging to ensure proper usage.
Confirm + and – polarity and follow the indications
when inserting new batteries into the remote control.
Do not use old and new batteries together.
Even if the battery is the same size, the voltage may
differ. Do not use batteries of different specifications
together.
Do not attempt to recharge batteries that are
non-rechargeable.
Do not open or disassemble batteries, throw them into a
fire or put them in water.
•
•
•
•
•
Inserting batteries
1. Open the lid.
2. Conrm+/-polarity,andinserttwoAAbatteries.
3. Closethelid.
ª
Batteries