Tascam CC-222SL CD Player User Manual


  Open as PDF
of 36
 
1- Introduction
16 TASCAM CC-222SL
Time display modes
When playing back a CD, or when in standby mode, there
are four different time display modes.
In each mode, the current track number is given, fol-lowed
by the time, as given below, e.g.
10Tr0:48
Press the DISPLAY key to cycle through these time display
modes, as described here:
Display shows Meaning
TOTAl Total elapsed time of the disc
TOTAl ReMAiN Time remaining of the current disc
[blank] Elapsed time of the current track
ReMAiN Time remaining of the current track
NOTE
If the Program playback has been selected (see
”Program playback” on page 17), the elapsed time and
total remaining time refer to the programmed material,
not the whole disc.
Track search
Use the MULTI DIAL (or the SKIP keys on the remote
control unit) to jump forward or backward by one track at a
time, as shown on the display.
Note that going forward from the last track of the disc will
“wrap round” to track 1, and going backward from the first
track of the disc will “wrap round” to the last track of the disc.
It is also possible to use the number keys on the remote
control unit to jump directly to a particular track:
1 Toplaytracks1through9,simplypresstheappro-
priatekey(1through9).
2 Toplayatrackwhosenumberishigherthan9,
pressthe+10keyanappropriatenumberoftimesto
setthe“ tens”digitofthetracknumber,followedby
asinglekeytosetthe“ units”digit.Forexample:
Track13=+10,3
Track30=+10,+10,+10,0
NOTE
On the remote control unit only, the search keys can be
used to ”fast-forward” and ”fast-rewind” through the disc.
Simple playback operations
WARNING
If you are monitoring using headphones, first adjust
the level control to low on the unit, then connect to the
PHONES jack before playing back. This will prevent
any possible damage to your hearing.
1 Insert a disc with the label side uppermost until the
unit pull the disc in.
When a disc is loaded into the unit, the display briefly
shows TOCReading., with a flashing period as the unit
determines the contents of the disc. When the TOC has
been read, the display shows (at the left of the display) one
of the following:
CD Commercial pre-recorded CD
CD-R/CD-RW Finalized CD-R or CD-RW
CD-R, NO TOC CD-R which has yet to be finalized
CD-RW, NO TOC CD-RW which has yet to be finalized
2 PressthePLAYkeytostartplayback
The track number indicators at the bottom of the display
light, to show the available tracks playing back. If there are
thirteen tracks on the disc, for example, indicators 1 through
13 will light. If there are more than 20 tracks on the disc,
“OVeR” will light at the end of the track number indicators.
Pressing the STOP key stops playback.
Pressing the PAUSE key pauses playback temporarily.
To resume playback, press the PAUSE key again or the
PLAY key.
4 – Disc operations
 previous next