Tascam CC-222SL CD Player User Manual


  Open as PDF
of 36
 
1- Introduction
30 TASCAM CC-222SL
7 – Cassette operating
Dubbing tapes from the CD deck
To record from the internal CD deck:
1 Prepareforrecordingasdescribedabove(loada
tape,settheREVMODE,etc.).
2 LoadthesourceCDdiscintotheunitwiththere-
cordedsidedown.
3 UsetheMENUkeytosetthedubbingvolumeto
THRUtobypasstheinputlevelcontrol(see“ Bypass-
ingtheinputlevelfordubbing”onpage23).
Ifyouwanttoadjusttheinputvolume,setthe
DUB>VOLmenutoONandusetheleft(tape)INPUT
controltoadjustthelevelofsignalsfedtothetape
fromtheCDplayer.
NOTE
If you want to record the tracks on the tape in a differ-
ent order from those on the disc, use the programmed
playback mode to rearrange the tracks (see “Program
playback” on page 17). Leave the disc in stop mode
when you have finished programming the order.
4 PresstheDUB 2key.
If the tape is in stop mode,thetaperewindstothe
beginningofthecurrentside.
Atthestartofthetape,recordingstarts,buttheCD
doesnotstartplaybackforeightseconds.The Dub
indicatorashes.
TheCDstartsplaybackaftertheeightsecondsat
thestartofthecassette.TheDub,2indicatorlights
steadily.
If the tape is in record standby mode,recording
startsimmediately,andtheCDstartsplaybackim-
mediately.TheDub,2indicatorlights.
The dubbing stops when playback reaches the end of the
CD, or when the tape reaches the end of its run (one side in
the case of single-sided (Ä) reverse mode, both sides in
the Ë reverse mode), whichever comes first.
Note that if the tape is set to auto-reverse, and the last item
recorded on one side of a tape was not completely recorded
before the tape was reversed, that item will be automati-
cally repeated.
Also note that when the tape automatically reverses, eight
seconds are used as non-recorded time at the beginning
of the second side (the tape is in record mode, but the CD
does not play back), again to allow for leader tape at the
start of the cassette.
The dubbing process can also be stopped manually with
the STOP key of the cassette deck or the CD deck. All
other transport keys are disabled.
NOTE
Dubbing is not possible if a cassette is not loaded, or
a CD is not loaded. It is not possible if the cassette is
write-protected, or if the CD is a recordable disc which
does not currently have any material recorded on it.
It is also not possible to enter the dubbing mode if the
tape is not in stop or record standby mode, or if the CD
is not in stop or pause mode.
Recording operations
Recording pre-recorded tapes, records, or other pub-lished
or broadcast material may infringe copyright laws. Check
before recording.
1 SettheREV MODEswitch.
Ifyouwanttomakeabi-directionalrecording,set
the REV MODEswitchtotheËoräposition.
SettotheÄpositionifrecordingistobemadeon
asinglesideofthetape.
2 Loadarecordablecassette.Checkthatthesafety
tabsonthespineofthecassetteareinplace.Ifthey
havebeenbrokenoff,blocktheholeswithadhesive
tape.
3 PresstheINPUT 2 SELkeytoselecteitherliNe2or
Discasarecordingsource.
When Discisselected,thebuilt-inCDplayer’sout-
putisselectedasasource.
When liNe2isselected,theexternalsignalfromthe
LINE 2jacksisselectedasasource.
4 SettheDOLBY NRsystemonoroff.
5 PresstheRECORDkey.Thedeckentersrecord
standbymodeandtheindicatorslightup.
6 Playbackthesource,andadjusttherecording
levelusingthetapedeck’sINPUTlevelcontrolso
thattheloudestsoundmakesthemetersbriey
reacharoundthe“ 0dB”pointfornormalorhigh-
positiontapes(recordingisnotpossiblewithmetal
tapes).
7 PresseitherthePAUSEorPLAYkeytostartrecording.
Tostoprecordingtemporarily,pressthePAUSE
key.Torestartrecording,presseitherthePAUSE
keyorPLAYkeys.IfthePLAYkeywhoseindica-
torisunlitispressed,therecordingdirectionwill
reverse,andthePLAYkeymustbepressedagainto
restartrecording.
8 Tostoprecording,presstheSTOPkey.
 previous next