Filter
Top Products
35Tact Audio
Connect your
M/S-2150 X to your
Computer
Your M/S-2150 X must be connected to your computers serial port in order for it to
communicate with your computer when you run the M/S-2150 X software. Please
follow the steps below to connect your M/S-2150 X to your computer.
1 - Connect the RS 232 Input jack on the back of the M/S-2150 X to your
computers serial port using the supplied cables and adapters. Your computer
must have a standard RS 232 serial port with a DB 9 connector.
NOTE: If you have any other Tact digital amplifiers please disconnect their
RS232 connection at this time.
2 - Turn on your M/S-2150 X.
3 - Turn on your computer and start the M/S-2150 X System Software.
NOTE: You may receive a communication error message. Please close the mes
sage window and proceed to the next step.
4 - Select the Com button on the main software screen to open the communica
tion window.
5 - Click on Help button for further instructions.
NOTE: If you are still not passing the communication test you may not have
a COM port installed on your computer or you may have another device
such as a modem or hand held PC that may be sharing the COM port on
your computer. If you have another Tact equipment attached it may be set
to the same address. The M/S 2150 X requires a valid COM port that is not
being used by any other devices.
NOTE: You will only have to select the communication port once. The next
time you run the M/S 2150 X correction software it will remember your set-
tings.
Software
M/S-2150 X