Filter
Top Products
72
Appendix: Manual Network Configuration
g. Turn the TUNE Knob to highlight Wired.
Press the TUNE Knob.
h. Will you be using DHCP? Turn the TUNE
Knob to highlight DHCP enable or DHCP
disable and press the TUNE Knob.
i. If you have selected DHCP disable, enter
the following information. Otherwise, continue with step j.
For each entry, Turn the TUNE knob to select the numbers, and press
the TUNE knob to confirm and move to the next number. Press BACK if
you entered an incorrect number.
TIP! You can use the Remote Control to increment the numbers ( ), and move
forward or backward through the number fields ( + and —).
i. Enter the IP address to use for the Radio.
ii. Enter the Subnet Mask IP address for the network.
iii. Enter the Gateway IP address for the
network.
iv. Enter the Primary DNS IP address for
the network.
v. Enter the Secondary DNS IP address
for the network, or leave blank if there
is none.
j. If you have entered the correct information, and the Radio is able to
connect to your network, the Connected screen will be displayed. If
not, the Failed to connect screen is displayed. This means that one or
IP settings
IP address
.
0
.
0
.
0
Subnet mask
.
255 255
.
255
.
0
0
Wired
Wireless
>
>
Connection type 1/9