Filter
Top Products
126
US
– Playback equipment (Blu-ray Disc
player, DVD player, etc.): up to 3
equipment
– Tuner-related equipment: up to 4
equipment (The receiver uses one of
them for its GUI operations.)
– AV receiver (audio system): up to 1
equipment
The MHL-compatible source device
cannot be charged.
• Check that the receiver is turned on.
• Make sure the device is connected
firmly.
No image from MHL-compatible source
device.
• Check the setting of your device. For
details, refer to the operating
instructions of your device.
• Check that device is connected via a
MHL cable to the HDMI/MHL
(VIDEO 2) IN jack (page 32).
The remote control does not function.
• Point the remote control at the remote
control sensor on the receiver
(page 10).
• Remove any obstacles in the path
between the remote control and the
receiver.
• Replace all the batteries in the remote
control with new ones, if they are
weak.
• Make sure you select the correct input
on the remote control.
• When you operate a programmed non-
Sony equipment, the remote control
may not function properly depending
on the model and the manufacturer of
the equipment.
If there is a malfunction, a message appears
on the display panel. You can check the
condition of the system by the message. If
any problem persists, consult your nearest
Sony dealer.
PROTECTOR
The receiver will automatically turn off
after a few seconds, check the
followings:
• There may be electrical surge or power
failure. Unplug the AC power cord
(mains lead), and then plug in the cord
again after 30 minutes.
• The receiver is covered and ventilation
holes are blocked. Remove the object
covering the ventilation holes of the
receiver.
• The impedance of the connected
speakers is below the rated impedance
range indicated on the back panel of
the receiver. Reduce the volume level.
• Unplug the AC power cord (mains
lead), let the receiver cool down for
30 minutes while troubleshooting the
followings:
– Disconnect all the speakers and
subwoofer.
– Check that the speaker wires are
tightly twisted on both ends.
– Connect front speaker first, increase
the volume level and operate the
receiver at least 30 minutes until it
completely warms up. Then, connect
each additional speaker one by one
and test each additional speaker until
you detect which speaker that is
causing the protection error.
After checking above items and fixing
any problems, plug in the AC power cord
(mains lead) and turn on the receiver. If
the problem persists, consult your
nearest Sony dealer.
Remote control
Error messages