Sony STR-DN1040 Stereo Receiver User Manual


 
119
US
Additional Information
There is a time gap between the audio
output and visual display.
Check that the PARTY STREAMING
function is not being used. To close a
PARTY, press PARTY CLOSE until
“CLOSE PARTY” appears. For
details, see page 73.
The FM reception is poor.
Use a 75-ohm coaxial cable (not
supplied) to connect the receiver to an
outdoor FM antennas (aerial) as shown
below.
Radio stations cannot be tuned in.
Check that the antennas (aerials) are
connected securely. Adjust the
antennas (aerials) and connect an
external antenna (aerial), if necessary.
The signal strength of the stations is
too weak with automatic tuning. Use
direct tuning.
Make sure you set the tuning scale
correctly (when tuning in AM stations
with direct tuning) (page 53).
No stations have been preset or the
preset stations have been cleared
(when tuning by scanning preset
stations is used). Preset the stations
(page 54).
Press AMP, then press DISPLAY
repeatedly on the remote control so
that the frequency appears on the
display panel.
The sound is distorted.
Press 2 – on the remote control
repeatedly. You can also use
MASTER VOLUME on the receiver.
Set the “EQ” setting of the iPod/
iPhone to “Off” or “Flat”.
There is no sound from the iPod/
iPhone.
Disconnect the iPod/iPhone and
connect the iPod/iPhone again.
The iPod/iPhone cannot be charged.
Check that the receiver is turned on.
Make sure the iPod/iPhone is
connected firmly.
The iPod/iPhone cannot be operated.
Check that you have removed the
protect case of the iPod/iPhone.
Depending on the contents of the iPod/
iPhone, it may take time to start
playback.
Turn off the receiver, then disconnect
the iPod/iPhone. Turn on the receiver
again and reconnect the iPod/iPhone.
You are using an unsupported iPod/
iPhone. See “Compatible iPod/iPhone
models” (page 47) for the supported
device types.
The ringtones volume of the iPhone
does not change.
Adjust the ring volume using the
controls on the iPhone.
Are you using a supported USB
device?
If you connect an unsupported USB
device, the following problems may
occur. See “Compatible USB devices”
(page 49) for the supported device
types.
Tuner
Receiver
Outdoor FM antenna (aerial)
iPod/iPhone
USB device