Filter
Top Products
45
GB
Getting Started
•CODE 31
1
Press , then follow the instructions from step
1 of “Performing the auto calibration.”
•CODE 32, 33
1
When you press , “RETRY?” appears.
2 Press V/v to select “YES,” then press .
3 Follow the instructions from step 2 of
“Performing the auto calibration.”
4 Press V/v repeatedly to select preset number to
store preset settings then press .
When you select “WRN CHECK”
If a warning on the measurement result is
present, detailed information is displayed.
Press to return to step 1 of
“Confirming/saving the
measurement results.”
When you select “PHASE INFO”
You can check the phase of each speaker (in
phase/out of phase).
Press V/v repeatedly to select a
speaker, then press to return to
step 1 in “Confirming/saving the
measurement results.”
CODE 33 (SR) • Either the left or right surround
speakers is not connected.
• Surround back speakers are
connected even though
surround speakers are not
connected. Connect the
surround speaker to the
SURROUND terminal.
CODE 33 (SB) The surround back speaker is
connected only to the
SURROUND BACK
SPEAKERS R terminal. When
you connect only one surround
back speaker, connect it to the
SURROUND BACK
SPEAKERS L terminal.
Warning code Explanation
WARNING 40 The auto calibration has
completed. However, the noise
level is high. You may be able to
perform the auto calibration
properly if you try it again, even
though the measurement cannot
be performed in all environments.
Try to perform the auto
calibration in a quiet
environment.
Error code Cause and remedies
WARNING 41 The sound input from the
optimizer microphone is outside
the acceptable range. It is louder
than the loudest sound that can be
measured. Try to perform the auto
calibration when the environment
is quiet enough to allow proper
measurement.
WARNING 42 The volume of the receiver is out
of the acceptable range. Try to
perform the auto calibration when
the environment is quiet enough
to allow proper measurement.
WARNING 43 The distance and position of a sub
woofer cannot be detected. Or the
angle of the speaker position
cannot be detected. This may be
caused by noise. Try to perform
the auto calibration in a quiet
environment.
NO WARNING There is no warning information.
Warning code Explanation
continued