Filter
Top Products
100
GB
The following operations are described for
connecting an IR repeater and operating the
receiver in zone 2. When an IR repeater is not
connected, use this receiver in the main zone.
1 Turn on the main receiver (this
receiver).
The remote switches to zone 2 mode.
2 Press ZONE 2.
3 Turn on the amplifier in zone 2 if
it is used in zone 2.
4 Press one of the input buttons
on the remote to select the
source signals you want to
output.
For zone 2, analog video and audio
signals are output. When you select
“SOURCE,” the signals of the current
input selected in the main zone are output.
5 Adjust to a suitable volume.
• In the case of illustration 1 (page 98),
you can only adjust the surround back
speaker volume in zone 2.
1 Set “SUR BACK SP” to “ZONE 2” in
the Speaker Settings menu (page 67).
2 Adjust the volume using MASTER
VOL+/– on the remote.
• In the case of illustration 2 (page 99),
adjust the volume using the receiver of
zone 2.
Tips
•Even when this receiver is turned off, the receiver
in zone 2 remains turned on. To turn off all
receivers, press ?/1 and AV ?/1 on the RM-
AAL003 remote at the same time (SYSTEM
STANDBY).
•Only signals from components connected to the
analog input jacks are output through the ZONE 2
jacks. No signals are output from components
connected to only the digital input jacks.
•When “SOURCE” is selected, the signals input to
the MULTI CHANNEL INPUT jacks are not
output from the ZONE 2 OUT jacks even when
MULTI IN is selected. The analog audio signals of
the current function are output.
• When “TUNER” is selected, the same type of radio
station (FM/AM/XM) selected in the main zone is
selected in zone 2. When the receiver in the main
zone is turned off, or an input source other than
“TUNER” is selected, you can select a broadcast
from FM/AM/XM in zone 2.
5
2
4