Filter
Top Products
38
GB
Insert two R6 (size-AA) batteries in the RM-
AAL003 remote commander.
Observe the correct polarity when installing
batteries.
Notes
•Do not leave the remote in an extremely hot or
humid place.
•Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
•Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
•If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
•When you replace the batteries, the programmed
remote codes may be cleared. If this happens,
program the remote codes again (page 104).
Tip
When the remote no longer operates the receiver,
replace all the batteries with new ones.
The receiver and the remote use the same
command mode.
If the command modes of the receiver and the
remote are different, you cannot use the
remote to operate the receiver.
If the command modes of both the receiver and
the remote are those of the initial setting (AV
SYSTEM 2), it is not necessary to reset them.
You can switch the command mode (AV
SYSTEM 1 or AV SYSTEM 2) of the receiver
and the remote. If both the receiver and the
other Sony component respond to the same
remote command, switch the command mode
of either the component or the receiver to
another command mode so that the component
does not respond to the same remote command
as the receiver.
To switch the command mode
of the receiver
Turn on the receiver while pressing
2CH.
When the command mode is set to “AV2,”
“COMMAND MODE [AV2]” appears on the
display.
When the command mode is set to “AV1,”
“COMMAND MODE [AV1]” appears on the
display.
Inserting batteries into the
remote
RM-AAL003
About the command mode
2CH