Filter
Top Products
ABOIJTTHE REMOTE CONTROL
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6(size AA) batteries.
R6(AA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Using the remote control
The instructions in this manual refer mainly to the buttons on the
main unit. In principle buttons on the remote control with the
same names as those on the main unit can be used as well.
mm
● If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
● The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor in the display window is exposed to intense light, such
as direct sunlight.
- Other remote controls are used nearby (those of a television,
etc.)
Remote control operation
This remote control system allows you to operate other external
equipment besides the AIWA receiver. For details c~fthe remote
control operation for other external equipment, see “REMOTE
CONTROL” on page 19.
The following is an explanation on how to operate the Aiwi~
receiver,
RECEIVER/DIGIT
AIWA
RECEIVER – SET UP
MUTE –
POWER –
TUNER PRESET/
SURROUND
FUNCTION
–+J ~+ VOLUME
1
2
Press the AIWA RECEIVER button to set
remote control to the Aiwa receiver mode.
Press one of the buttons indicated above.
the
FUNCTION button
Each time this butlton is pressed, the sound source changes
cyclically.
TUNER PRESET/SURROUND buttons
Tune in the station which has been preset on the receiver.
To go to a higher preset number, press the UP-II button. To
go to a lower preset number, press the DOWN K< button.
This button is also used when adjusting the speaker level
balance of the DSP, Dolby Pro Logic or Dolby Digital Surround
mode.
EmE!
It is not necessary to press the AIWA RECEIVER button each
time you operate the Aiwa receiver unless another mode has
already been set. (See “REMOTE CONTROL” on page 19.)
If the receiver cannot be operated with the remote
control
Follow the steps below using the remote control.
1
2
3
Press the AIWA RECEIVER button.
Press and hold the SET
UP button for about 2.5
seconds.
The indicator on the top of the remote control blinks twits
while pressing the button.
Press the DIGIT buttons in the order of “4:’ “O”
and “6.”
(’
IENGLI$H )