Filter
Top Products
CONNECTING SPEAKERS@)
Front speakers
.
——
Speaker terminals
Connect front speakers (system A and/or B), a center speaker,
Lift up the terminal flap,
surround speakers and sub woofer to the corresponding speaker
insert the speaker cord lead
terminals on the unit:
into the terminal slot, then
- the front speaker cords to the FRONT SPEAKERS terminals
close the flap. Check that the
- the center speaker cord to the CENTER SPEAKER terminals
cord is connected securely.
- the surround speaker cords to the SURROUND SPEAKERS
terminals
I
- for more powerful bass, the sub woofer (with a built-in amplifier)
L ———.
cord to the SUPER WOOFER 4 jack
Surround speakers
When not connecting the sub woofer, be sure to select the
“SUBW OFF (sub woofer off) mode (see page 7),
Speaker’ impedance
* Front and center speakers
Use the same impedance for both the front and center speakers.
The SPEAKER IMPEDANCE SELECTOR on the rear should be
set to the position that matches the impedance value of the front
and center speakers,
When using 4 ohm speakers, set the selector to IMP: 4Q. When
using 8 ohm speakers, set the selector to IMP: 8Q. PIease unplug
the AC cord before setting the selector,
* Surround speakers and super woofer
The SPEAKER IMPEDANCE SELECTOR has no effect on the
SURROUND SPEAKERS terminals and the SUPER WOOFER
\
Kljack. For the surround speakers and sub woofer, use speakers
SPEAKER———
of 8 ohms or more.
IMPEDANCE
SELECTOR
Connecting + to +, -to - terminals
To get the proper sound effect, the speaker terminals on the unit
.\
“n
—
——————7/-----”
and the speaker should be connected with proper polarity; the +
‘@
____”_/~
terminal on the unit should be connected to the + terminal on
the speaker (and – to –),
L
H
,
●,,4
,0
fnmi
● Be sure to connect the speaker cords correctly as shown in
b
e-
the illustration on the right column. Improper connections can
cause short circuits in the SPEAKER(S) terminals.
%
c Do not leave objects generating magnetism near the speakers.
\
Sub woofer
Center speaker
ENGLISH ‘$